AMX SIP Communications Gateway CSG-500 - Manual (Page 81)

Device Configuration
73 CSG SIP Communications Gateway Operation/Reference Guide
Configuration Page - SIP Settings Tab
The options on the SIP Settings tab of the Configuration page are used to set the proxy server address
and port and the username and password to log into the server. These settings enable VoIP and enable
you to give your Metreau Entry Communicator phone capabilities to contact other units, such as
intercom-enabled touch panels and IP phones.
FIG. 68 Configuration page - SIP Settings tab
Configuration Page - SIP Settings Tab
Username This option enables you to enter the user name used for authentication to the proxy
server. Normally, the user name is the same as the extension you are using.
Password This option enables you to enter the password for the user at the proxy server.
Server Address This option enables you to enter the IP address or DNS name of the proxy server that
you want to use to register. The IP address depends on whether you connect the entry
communicator to one of the IP Phone ports or through the LAN with the CSG.
Server Port The option displays UDP the port you use to connect to the proxy server. The standard
SIP port is 5060, but some providers use different ports.
STUN Address This option enables you to enter the IP address or DNS name of the Simple Traversal of
UDP through NATs (STUN) server. This field is optional.
Local Domain This is the realm used for authentication. This field is optional.
Enable Phone This option enables the SIP Stack on startup. If you disable this option, the Metreau
Entry Communicator will not attempt to read the rest of the configuration and will not
register with a proxy server. However, point-to-point SIP will still be enabled allowing for
existing intercom functionality
Connection Displays whether your connection to the proxy server is registered. This field is
view-only.