Agilent Technologies 664xA - Manual (Page 67)

Index 67
Index
—A—
AARD, 15
analog port. See chapter 4 in the Operating Guide
analog programming. See chapter 4 in the Operating Guide
ANSI/IEEE, 7, 57
ARPS commands, 64
—C—
CAL bit. See status bit
calibration
password. See appendix A in the Operating Guide
procedure. See appendix A in the Operating Guide
CC
mode, 17, 41
CC bit. See status bit
character strings, 15
combine commands
common commands, 14
from different subsystems, 13
root specifier, 13
command completion, 57
common commands
*CLS, 27
*ESE, 27
*ESR?, 28
*IDN?, 28
*OPC, 28
*OPC?, 29
*OPT?, 29
*PSC, 29
*RCL, 30
*RST, 31
*SAV, 31
*SRE, 32
*STP?, 32
*TRG, 33
*TST?, 33
*WAI, 33
Compatibility
language, 63
connector
digital port. See appendix D in the Operating Guide
trigger, 16
conventions used in this guide, 9
CRD, 15
current, 16
CV
mode, 17, 41
CV bit. See status bit
—D—
data
boolean, 15
character, 15
multiplier, 15
numeric, 14
suffix, 15
DCL command, 29, 33
DDE bit. See status bit
DFI, 57
discrete fault indicator, 57
display
writing to, 17
DOS drivers, 20
—E—
error messages, 59
calibration. See appendix A in the Operating Guide
hardware. See chapter 3 in the Operating Guide
runtime. See chapter 3 in the Operating Guide
system, 59
error queue, 44, 59
ESB bit. See status bit
EXE bit. See status bit
—F—
factory default state. See common comands, *RST
FLT, 57
—G—
general information, 7
GET command, 33, 59
GPIB
address, 18
capabilities of the dc source, 9
command library for MS DOS, 7
connections. See chapter 4 in the Operating Guide
controller programming, 7
references, 7
—H—
hazard
energy, 2, 30
header, 11
long form, 11
short form, 11
history, 2
—I—
trigger, 16
implied
colon, 13
decimal point, 14
message terminator, 15
INH, 57
initial conditions, 54
trigger, 16