Configuration, Configuring network access, Configuring user accounts – HP ProLiant DL145 G3 Server User Manual
Page 10
Configuration 10
Configuration
Configuring network access
Your server is connected to the network using a standard Ethernet cable. Through this connection, you can
access the remote management CLP, verify POST remotely, and access the BIOS Setup Utility remotely.
To configure network access:
1.
Connect a standard Ethernet cable from the LO100 to a network jack.
o
On HP ProLiant ML150 G3, ProLiant ML110 G4, and ProLiant ML115 G1, servers, connect the
NIC port on the remote management card.
o
On HP ProLiant DL140 G3 and ProLiant DL145 G3 servers, connect the onboard LO100 NIC.
2.
Obtain the DHCP IP address, by using either of the following methods:
o
Look at the DHCP clients table.
o
Press the F10 key during POST, and obtain the IP address from BIOS Setup Utility under
Advanced/IPMI/LAN Setting. See "Obtaining a DHCP IP address from the BIOS Setup Utility (on
page
)" for more information.
By default, LO100 has DHCP enabled and automatically negotiates an IP address.
3.
With the DHCP IP address, use telnet to log in to the remote management CLP, or use a web
browser to access the HTML interface.
To set up a static IP address, see "Setting up a static IP address from the BIOS Setup Utility (on page
for more information.
Configuring user accounts
LO100 supports four accounts types, with varying levels of permissions to view and control features. For
more information on user accounts, see the "User administration (on page
)" section. Two accounts are
available by default, one of type administrator and one of type operator.
The administrator account enables the user to execute the full set of CLP commands and change
management processor configuration. The default administrator account user name is admin, and the
default password is admin.
The operator account enables the user to execute common commands and functions but restricts access to
specific functions, such as adding and changing user account information and changing the configuration
of the management processor. HP recommends logging in with the operator account to perform common
functions. The default user name is Operator, and the default password is Operator.
For more information on how to log in to LO100, see the "Logging in to LO100 (on page
)" section.