Avaya P332G-ML - Manual (Page 33)

Avaya P332G-ML User’s Guide 17
Chapter 4
Installation
The P332G-ML is ready to work after you complete the installation instructions
below.
Required Tools
Make sure you have the following tool at hand before undertaking the Installation
procedures:
•
Phillips (cross-blade) screwdriver
Site Preparation
You can mount Avaya P330 switches alone or in a stack in a standard 19-inch
equipment rack in a wiring closet or equipment room. Up to 10 units can be stacked
in this way. When deciding where to position the unit, ensure that:
•
It is accessible and cables can be connected easily and according to the
configuration rule.
• Cabling is away from sources of electrical noise such as radio transmitters,
broadcast amplifiers, power lines, and fluorescent lighting fixtures.
• Water or moisture cannot enter the case of the unit.
• There is a free flow of air around the unit and that the vents in the sides of the
case are not blocked.
L Use Octaplane cables to interconnect with other switches.
•
The environmental conditions match the requirements listed below:
Table 4.1 Environmental Prerequisites
Operating Temp. -5 to 50°C (23 to 122°F)
Relative Humidity 5% to 95% non-condensing