Avaya P332G-ML - Manual (Page 70)

Chapter 8 User Authentication
54 Avaya P332G-ML User’s Guide
Allowed Managers
Allowed Managers Introduction
With the Allowed Managers feature, the network manager can determine who may
or may not gain management access to the switch. The feature can be enabled or
disabled (default is disabled). When enabled, only those users that are configured in
the Allowed Managers table are able to gain Telnet, HTTP, and SNMP management
access to the switch.
You can configure up to 20 Allowed Managers by adding or removing their
IP address from the Allowed Managers List.
L The identification of an “Allowed Manager” is done by checking the Source
IP address of the packets. Thus, if the Source IP address is modified on the way
(NAT, Proxy, etc.), even an “Allowed Manager” will not be able to access the
P330.
Allowed Managers CLI Commands
The following Allowed Managers commands are available.
In order to... Use the following command...
When set to enabled - only
managers with IP address specified
in the allowed table will be able to
access the device set allowed managers
Add/delete IP address of manager
to/from the allowed table set allowed managers ip
Show the IP addresses of the
managers that are allowed to access
the device show allowed managers table
Show whether the status of allowed
managers is enabled or disabled show allowed managers status
Show the IP addresses of the
managers that are currently
connected show secure current