Avaya P332G-ML - Manual (Page 67)

Chapter 8 User Authentication
Avaya P332G-ML User’s Guide 51
Radius Commands
The following RADIUS commands are accessible from Supervisor level.
For a complete description of the RADIUS CLI commands, including syntax and
output examples, refer to Avaya P330: Reference Guide.
In order to... Use the following command...
Enable or disable authentication for
the P330 switch. RADIUS
authentication is disabled by
default set radius authentication
Set a primary or secondary
RADIUS server IP address set radius authentication server
Configure a character string to be
used as a “shared secret” between
the switch and the RADIUS server set radius authentication secret
Set the RFC 2138 approved UDP
port number. set radius authentication udp-port
Set the number of times an access
request is sent when there is no
response set radius authentication
retry-number
Set the time to wait before
re-sending an access request set radius authentication retry-time
Remove a primary or secondary
RADIUS authentication server clear radius authentication server
Display all RADIUS authentication
configurations. Shared secrets are
not displayed. show radius authentication