American Dynamics RAS917WLS-1 - Manual (Page 107)

If you want to … Use …
Reset Dome Run/Pgm switch to PGM
Enter 97 Enter
Auto Pan Left Limit
See Setting Left and Right Auto Pan Scan Limits on
page F–4.
Run/Pgm switch to PGM
Enter 98 Enter
Auto Pan Right Limit
See Setting Left and Right Auto Pan Scan Limits on
page F–4.
Run/Pgm switch to PGM
Enter 99 Enter
Auto Pan ON/OFF
(LED indicates Auto Pan state: ON = Auto Pan is
running.)
Run/Pgm switch to RUN
A/P toggles state
Operating the Dome Configuration Menu
The following table lists the commands to operate the configuration utility when the dome is installed
in a Vicon environment.
If you want to … Use …
Start the configuration utility. Run/Pgm switch to PGM Enter 94
Enter
Move the highlight bar on the active menu. Tilt Up/Down
Select the highlighted item on the active menu. A/P or AUX5
Increase the value of the selected setting.
For example, Red or Blue white balance values. Pan Right (or Zoom In)
Decrease the value of the selected field.
For example, Red or Blue white balance values. Pan Left (or Zoom Out)
Display the next choice for the setting. For example,
Maximum Zoom setting. Pan Right (or Zoom In)
Display the previous choice for the setting. For
example, Maximum Zoom setting. Pan Left (or Zoom Out)
Vicon Protocol Command Summary F–3