American Dynamics RAS917WLS-1 - Manual (Page 95)

Panasonic UTC Command Summary
The following table lists the commands to operate the configuration utility when the dome is installed
in a Panasonic UTC environment.
If you want to … Use …
Start the configuration utility. Camera Set ON
Set Up/Esc + Camera
Move the highlight bar on the active menu. Up/Down
Select the highlighted item on the active menu. SET
Increase the value of the selected setting. For example, Red or
Blue white balance values. Right
Decrease the value of the selected field. For example, Red or
Blue white balance values. Left
Display the next choice for the setting. For example,
Maximum Zoom setting. Right
Display the previous choice for the setting. For example,
Maximum Zoom setting. Left
Adjust dome position during menu programming. ALT
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available characters in
the selected languages. In these situations, the following commands are used:
If you want to … Use …
Move the highlight left or right in the character field. ALT enabled, Left/Right
Move the highlight up or down in the character field. ALT enabled, Up/Down
Select the highlighted character in the character field. SET
Move the cursor to the right of the current character in the
name or password. ALT disabled, Right
Or
ALT enabled, Zoom Tele
Move the cursor to the left of the current character in the
name. ALT disabled, Left
Or
ALT enabled, Zoom Wide
Panasonic Up-the-Coax (UTC) Protocol Command Summary D–3