American Dynamics RAS917WLS-1 - Manual (Page 97)

5. Use the joystick to move the highlight to Presets. Press Set to select. The Select Preset to
Program screen displays.
SELECT PRESET TO PROGRAM
PRESET
NUMBER PRESET NAME
1-64 PRESET 1-64
FOCUS FAR to program preset
EXIT
6. Use the joystick to select the Preset you want to program. If the Preset has been programmed the
dome automatically moves to that position.
• Move the joystick right to increase the preset number.
• Move the joystick left to decrease the preset number.
When the correct Preset number appears, press Set to begin programming.
7. The Presets screen displays. Use the joystick to adjust the dome to the correct pan/tilt position.
PRESETS
PRESET X
Position camera with PAN
TILT, ZOOM and IRIS
FOCUS FAR to save and exit
EXIT
IMPORTANT! If using the WV-CU550A Controller with the WJ-SX550 Multiplexer, you must
press F3 (A. Res) to adjust the zoom, focus, or iris settings. This places the controller in normal
navigating mode. Make the necessary adjustments. When finished, press F1 (On) to resume
menu mode.
8. Press Set to save the Preset information.
9. To program more Presets, repeat steps 5 through 8. To exit the Dome Configuration Menu and
save changes, press F4 (Exit).
To verify the Preset programming, enter a Preset number (1-64) and press Preset.
Tested Panasonic Equipment
The following Panasonic equipment has been tested with SpeedDome Ultra VII:
• WJ-SX550 Multiplexer
• WV-CU550A Controller
Panasonic Up-the-Coax (UTC) Protocol Command Summary D–5