Installation manual, Step 1 – Ultra Start 25XX Series User Manual

Page 10

Advertising
background image

Step 1

- Connect All Of the Following Wires

6 Pin Power Connector

Yellow

30amp Starter Output 12volts during start position only.

Green

30amp Heater Output 12volts in the accessory position off during start and 12volts

during the run position.

Red

30amp Power Input

Constant 12volt power at ignition harness or battery.

Red

30amp Power Input

Constant 12volt power at ignition harness or battery.

Blue

30amp Ignition Output 12volts in the ignition, start and when run positions.

White

30amp Select Output* Selectable Output for vehicles that require 2nd Ign, Acc or

Starter wires. See jumper diagram.

Note: The white wire may not be required on all vehicles.

Auxiliary Connectors

Black

System Ground Input - Connect to Chassis Ground.

White

Park Light Output - Connect to (+) Park Light system.

Green/Wht

Hood Pin Input - Connect to the Hood Pin Safety Switch.

Blue/White

Tach - Connect To A/C Tach Source. (Above 2volts AC)

Pink

Brake Switch - Connect To (+) When Brakes Is Applied.

White/Blue

Siren Output - Connect to Siren/Horn

Manual Transmission Connections (”M” Models Only)
Black/Wht

Park Brake Input - Connect to Park Brake wire.

Green*

(-) Door Pin Input - Connect to door pin (-) when doors opened.

Purple*

(+) Door Pin Input - Connect to door pin (+) when doors opened.

Note: Connect only one of the door pin inputs. If the vehicle has a positive door pin system

connect the purple wire, if negative connect the green wire.

Never install an automatic module into a manual transmission vehicle!

Step 2- Plug-In The Module

When all the connections are done, the control module can be plugged in. Before

connecting the control module, make sure the ignition is in the OFF position. Plug in the
6 pin harness and the Auxiliary harness, then any other connectors that were used. The
park lights will flash and the horn will chirp 2 times to confirm power up on automatic
transmission models. Manual transmission models will flash the park lights and siren

4 times to confirm power up.

Page 10

INSTALLATION MANUAL

REMOTE VEHICLE STARTER/ALARM

Advertising
This manual is related to the following products: