Ultra Start 25XX Series - Manual (Page 15)

Quick View Programming
* See the following pages for more detailed programming instructions.
Menu 1 - Press Lock
1 Flash 2 Flashes 3 Flashes
1 Ignition Lock Enabled Lock Only Disabled
2 Siren Chirp Type 1 Type 2 All Chirps
3 Lock&Unlock Options Double Unlock 3 second .75 second
4 Unlock/Disarm 125ms 750ms
5. Passive Locks Enable Disable
6. Shock Sensor Disable Enable
7. Passive Arming Type 1 Type 2 Disable
8. Auxiliary Outputs Type 1 Type 2 Disable
Menu 2 -Press Unlock 1 Flash 2 Flashes 3 Flashes
1 Secure Service Mode 15 seconds 5 seconds
2 Park Light Output 30 seconds (-) Park Light Light Flash
3 Horn Timing 5ms 50ms 10ms
4 # Button Trunk Release Garage Door Car Finder
5 Reservation Mode Manual Auto Reservation- Manual Models
Menu 3 -Press Start 1 Flash 2 Flashes 3 Flashes
1 Lock/ Unlock Type Type 1 Type 2 Normal
2 Gas/ Diesel Negative 15 second Gas/ Positive
3 Rearm Output Type 1 Type 2 Rearm
4 Run Time 4 Min 45 Min 15 Min
5 Crank Time 10 seconds 3 seconds 5 seconds
6 Starter Disable/GWR Active Passive GWR
7 Safety Start Mode Press twice Press once
8 Programmable Input (+) Instant Start (+) Disconnect
Menu 4 -Press # 1 Flash 2 Flashes 3 Flashes
1 Low Idle Learn Low Idle Learn
2 Adjust For Over Crank Reduced by 10%
3 Adjust For under Crank Increased by 10%
**Bold type indicates settings that are Factory Default.
Page 15
REMOTE VEHICLE STARTER/ALARM
INSTALLATION MANUAL
System Reset
The system reset will clear any changes made to the Program Menu’s as well as the
Tach setting. When the system reset is complete the system must be Tach learned
before the remote starter will operate.
1) Turn the ignition key from “Off” to “On” 3 times, ON-OFF-ON-OFF-ON within three
seconds. (Leave the key in the ON position)
2) Press and release the Program Button located on the antenna. The park lights will
turn on and the siren will chirp one time.
3) Then press and hold the Program Button until the park lights flash and the siren
will chirp 3 times slowly to confirm system reset.
System is now reset to factory defaults.
Note: System Reset does not delete the transmitter codes from memory.