Installation manual, Continued from previous page – Ultra Start 25XX Series User Manual

Page 8

Advertising
background image

Page 8

INSTALLATION MANUAL

REMOTE VEHICLE STARTER/ALARM

14 Pin Connector

Continued From Previous Page

1-Green

Door Lock

Door Lock Output - Programmable Menu 1

2-Red

12vlt Output

Output For Door Lock Module Only!

3-Blue

Door Unlock

Door Unlock Output - Programmable Menu 1

4-Pink

2nd Unlock

Output when button #2 is pressed twice.

* The centre pin of the keyless entry harness is not to be used for anything
besides plug-in devices such as the VP-1, DL-3, DL-7 and Data Bus Modules.
Overloading this output will damage the remote starter.

3 Pin Connector Red

11-Blue/White

Tach

A/C Tach Signal Input. Used to detect when the
vehicle has started. This wire is connected to the
vehicles coil, fuel injector or crank sensor wire.

12-Blue

Glow Plug

Diesel Glow plug input, detects both 12volt and

negative glow plug signals. Programmable input.

13-White

Park Lights

+10amp park light output. At light harness 0volts when
Park lights are off, 12volts when park lights are on.

14-Black/ Park Brake

Input to detect Park Brake Switch. Connect to wire at

White

the switch that switches to (-) when the switch is applied.

White/Green

LED Output Pulsed negative output for LED activation.

Black

Dome Light Negative Output For Dome Light Supervision.

White/Blue

Siren

Positive Output For Siren.

Red

Trunk Pin

Negative Input For Trunk Pin Switch.

4 Pin Connector Square

3 Pin Connector White

Green*

Auxiliary 1

Programmable Output. Press buttons #1 and #3

Pink

Auxiliary 2

Programmable Output. Press buttons #2 and #3

Blue

(+) Disconnect (+) Disconnect Or Instant Start Trigger.

*The default setting of the green wire is Negative Horn Output.

Auxiliary outputs are designed to work with the 26xx Series.

2 Pin Connector White

If the Temperature Sensor is installed the Cold Start Mode will operate by
monitoring temperate. If the sensor is not installed the Cold Start Mode will
function as Timer Mode. The temperature sensor can be installed under the
hood strapped to the radiator hose to monitor coolant temperature or left
mounted under the dash to monitor ambient air temperature.

Advertising
This manual is related to the following products: