Ultra Start 25XX Series - Manual (Page 7)

Page 7
REMOTE VEHICLE STARTER/ALARM
INSTALLATION MANUAL
6-pin Description Test For Wire
1-Yellow 30amp Starter Output This wire will test 0volts in off, accessory and in
the ignition position.12volts during start only.
2-Green 30amp Heat/Acc Output This wire will test 0volts in the off position 12-
14volts in the accessory and run positions and
0 volts during start
3-Red 30amp Power Input 12volts at ignition harness or from battery.
Supplies power for the ignition, selectable
output and park light relays.
4-Red 30amp Power Input 12volt power at ignition harness or from battery.
Supplies power for accessory and start relays
5-Blue 30amp Ignition Output This wire will test 0volts in the off and accessory
position 12volts in the ignition, start and run.
6-White 30amp Select Output Selectable output for 2nd Ign, acc or starter.
14 Pin Function Description
1-Yellow Re-Arm 0.75 second Pulsed output when locked and on
remote start shutdown. Used for factory alarm re-
arm. Programmable output. See Menu 3
2-Orange St.kill and Anti-Grind Negative output when locked and during remote
start. Used for optional starter disable, and anti-
grind relay. Programmable output. See Menu 3
3-Brown Disarm 0.75sec pulsed output when Unlocked and pulse
before remote start activation. Used for Factory
Alarm Disarm.
4-Red/Wht Trunk Release Hold the unlock button for 3 seconds. Output will
stay on until the unlock button is released (Max 5
seconds Programmable to (-)Park lights.
5-Wht/Violet GWR (-) Output while remote starter is activated. Used to
activate Anti-thef bypass modules.
6- Green (-) Door Pin Input to detect door opening. Connect to door pin
that switches to (-) when the door is opened.
7-Green/ Hood Pin Negative input from hood pin safety switch. Switch
White is grounded when the hood is opened.
8-Purple (+) Door Pin Input to detect door opening. Connect to door pin
that switches to 12volts when the door opened.
9-Pink Brake input Positive Brake Input. Used to detect the brake
switch being applied. Found at the brake switch
connector.
10-Black Ground System Chassis Ground Input.
Continued on next page.
6 Pin Power Connector
14 pin connector