Ultra Start 25XX Series - Manual (Page 20)

Menu 4- Tach Settings
Setting 1 Auto Tach Learn.
1) Perform a System Reset. See page 15.
2) Turn the ignition key on. (Park lights will turn on).
3) Start the vehicle, the LEDs on the antenna will come on when a proper tach signal is detected*.
4) After approximately 30-35 seconds the park lights will go out then will flash twice and the siren
will chirp twice to confirm that a tach signal has been learned.
Setting 2 Over-Crank Adjustment.**
1) Enter Program Mode (turn ignition ON-OFF-ON-OFF-ON), press and release the Program Button.
2) Press and release the # button on the remote.
3) Press and release the Program Button twice. (LEDs will flash 2 times consecutively)
4) Press and hold the Program Button. The park lights flash and the siren will chirp one time.
*Each time the park lights flash and the siren chirps the setting is reduced.
5) Release the Program Button. (Exit Program Mode and test remote starter)
Setting 3 Under-Crank Adjustment.**
1) Enter Program Mode (turn ignition ON-OFF-ON-OFF-ON), press and release the Program Button.
2) Press and release the # button on the remote.
3) Press and release the Program Button three times. (LEDs will flash 3 times consecutively)
4) Press and hold the Program Button. The park lights will flash and the siren will chirp one time.
*each time the park lights flash and the siren chirps the setting is increased.
5) Release the Program Button. (Exit Program Mode and test remote starter)
Page 20
INSTALLATION MANUAL
REMOTE VEHICLE STARTER/ALARM
Setting 6 Anti-Grind/Starter Kill (Orange wire on 14-pin)
1) Active
1 Flash/chirp (-) when locked and during remote start (Anti-Grind).
2) Passive 2 Flashes/chirps (-) when locked /30 seconds after ignition is Off or unlock is pressed
*3) Anti-grind 3 Flashes/chirps Output during remote start only. (Anti-grind/ Bypass module)
Press & Release the Program Button 6 Times (Setting 6) Confirmed with 6 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 7 Safety Start
1) Safety On
1 Flash/chirp Press the start button twice within 3seconds to remote start vehicle.
*2) Safety Off 2 Flashes/chirps Press the start button once to remote start vehicle.
Press & Release the Program Button 7 Times (Setting 7) Confirmed with 7 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 8 Positive disconnect/ Instant Start (Blue wire on 3-pin side connector)
1) Instant Start
1 Flash/chirp 12volt trigger will activate remote starter
*2) (+) Disconnect 2 Flashes/chirps Removing 12volts from this wire will trigger alarm.
Press & Release the Program Button 8 Times (Setting 8) Confirmed with 8 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.