Ultra Start 25XX Series - Manual (Page 14)

Entering Program Mode
1) With the ignition in the OFF position, turn the ignition key from “Off” to “On” 3 times,
ON-OFF-ON-OFF-ON within three seconds. (Leave the key in the ON position)
2) Press and release the Program Button located on the antenna. The park lights will
flash and the siren will chirp to confirm entering program mode.
3) Select desired Program Menu (See below). The park lights will flash and siren
will chirp to confirm the selected menu.
4) Select Programmable Setting:
a) Press and release the Program Button the correct number of times to select the
desired Program Setting. The park lights and LEDs will flash and the siren
will chirp to indicate the Program Setting that has been selected. For example:
1 flash/chirp= Program Setting 1; 2 flashes/chirps= Program Setting 2; etc…
b) Press and Hold the Program Button until the park lights flash and the horn(optional)
chirps to confirm the desired setting. For example: 1 flash/chirp= Setting 1;
2 flashes/chirps= Setting 2; 3 flashes/chirps= Setting 3.
c) Turning the ignition key to the “Off” position or 30 seconds of no activity will exit
Program Mode. This will be confirmed with a light flash and a long siren chirp.
The Program Menu may be changed at any time by pressing the transmitter
button (below), this will allow the installer to jump from one menu, then quickly jump
to another menu and change another setting without re-entering Program Mode.
Note: If unit does not enter Program mode, turn ignition off for 5 seconds and repeat
steps 1-4.
Page 14
INSTALLATION MANUAL
REMOTE VEHICLE STARTER/ALARM
Menu 1: User Settings (Lock Button) Page 16
This program menu is for the adjustments for the user and door lock options.
Menu 2: Additional Settings (Unlock Button)
Page 17
This program menu is for additional settings.
Menu 3: Starter Settings (Start Button)
Page 18-19
This program menu is for various remote car starter applications.
Menu 4: Tach Settings (# Button)
Page 20
This program menu is for tach signal adjustments.
Program Menus
Ignition 3x
On/Off
On/Off On
Press and
Release
Press the
Lock button
for Menu 1 Press the
Unlock button
for Menu 2 Press the
Start button
for Menu 3 Press the
# Button
for Menu 4