Ultra Start 25XX Series - Manual (Page 6)

Page 6
INSTALLATION MANUAL
REMOTE VEHICLE STARTER/ALARM
Side View
PIN 4
RED
P N 4 I
W E HIT
4 PIN
WHITE
P N 3 I
WHITE
Note-250ma outputs are low current and are designed to activate
relays
Green
Pink
Blue
Programmable* AUX #1 (Hold 1&3)*/ (-) HORN OUTPUT*
AUXILIARY OUTPUT #2 (Hold 2&3) Programmable
(+) Input (+)DISCONNECT/ (+) START INPUT**
Sensor Full-Warn Input
Sensor Pre-Warn Input
Sensor Ground Output
Sensor 12V+ Power Output
Black
Red
Blue
Green
(-)Input
(-) Input
(-)250ma Output
(+)250ma Output
Door Lock
12volt Inverter Output
Door Unlock
Passenger Door Unlock
Red
Blue
Pink
Green (-)250ma Output
(+)250ma Output
(-)250ma Output
(-)250ma Output
Jumper Selections - Back View
Jumper Access
3 2 1
The jumpers control the output from the White wire on the 6- pin harness. This is
a 30amp relayed output. To change the output of the wire access the jumpers by
sliding the plastic cover off the top of the case. Move the jumper to one of the
following positions.
If the jumper is in position #1 the output on the white wire will be 2nd Starter
If the jumper is in position #2 the output on the white wire will be 2nd Accessory
If the jumper is in position #3 the output on the white wire will be 2nd Ignition
Note: The factory default setting of the selectable output jumper is position
#3 second ignition output.
*The default output of the Green wire is Negative Horn Output. The auxiliary
outputs must be programmed on before they will operate.