HP XP Racks - Manual (Page 130)

The following shows an example of copying the
sample_installhdlm.conf file, and then changing the file name to
install_set.conf:
# cp -p /cdrom/HDLM_AIX/hdlmtool/instutil/
sample_installhdlm.conf /any-directory/install_set.conf
For details about how to edit the installation information settings file,
which is used by the installhdlm utility, see Items To Be Defined in an
installation-information Settings File on page 7-27 .
Additionally, since HDLM must be restarted after installation, change the
setting for the restart key in the installation information settings file
from n to y.
#
#
After you have performed an unattended installation, you can also
manually restart HDLM.
If you plan to manually restart HDLM, you do not need to change the
setting for the restart key in the installation information settings file
from n to y.
However, in that case, this procedure must be modified as described
below:
- The host does not restart after the KAPL09211-I message is output
(step 11).
- Before you perform step 13, execute the following command to
restart the host:
# shutdown -Fr
11
.
If a single-path configuration is used, connect cables to all HBAs to
change the configuration to a multi-path configuration.
Note that, regardless of the configuration, do not execute the cfgmgr
command.
12
.
Execute either of the following commands:
To execute installux.sh:
# /cdrom/installux.sh -f /any-directory/installation-
information-settings-file
To execute installhdlm:
# /cdrom/HDLM_AIX/hdlmtool/instutil/installhdlm -f /any-
directory/installation-information-settings-file
Even though a message asking you to restart the host is displayed during
installation, you do not have to restart the host.
During installation, the KAPL09241-W message might be output. In this
case, installation of HDLM continues, but installation of HDLM components
has failed. After installing HDLM, resolve the problem according to the
KAPL09241-W message if necessary.
When installation is successful, the KAPL09211-I message is output and
the host restarts. After the host has restarted, check to make sure that
3-68
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for AIX®