HP StorageWorks XP Remote Web Console Software - Manual (Page 16)

Table 1 System Option Modes (continued)
Description Mode
When creating a Universal Replicator for Mainframe pair
for delta resync operation in the 3DC multi-target
configuration, and if you want to control the ratio of the
usage rate of difference journal data in the journal volume
in the primary site, set this mode to ON.
Mode 511 ON: The upper limit of the usage rate of the
journal data in the journal volume is 40%.
Mode 511 OFF: The upper limit of the usage rate of the
journal data in the journal volume is 70%.
511
To change the displayed consistency time (C/T) when the
Universal Replicator for Mainframe pair status is Duplex,
set this mode to ON.
Mode 530 ON: The copy completion time from the master
journal volume to the restore journal volume of the journal
data is displayed in C/T.
Mode 530 OFF: The completion time when the journal
data is restored to the data volume is displayed in C/T.
530
In the configuration where multiple MCUs share an RCU
(Universal Replicator for Mainframe Mx1 configuration),
the mirror resynchronization or delta resync operation may
fail due to SSB=EB9D. SSB=EB9D is output as SSB log
when the parameter of the communication command is not
saved in the shared memory. To reduce the number of
multiprocessing of the communication command issued
from MCU to RCU for the status transition of each pair, set
this mode to ON. By setting this mode to ON, you can
prevent mirror resynchronization or delta resync operation
from failing.
Mode 593 ON: The multiprocessing of the communication
command issued from MCU to RCU is up to 128 pairs per
DKC.
Mode 593 OFF: The multiprocessing of the communication
command issued from MCU to RCU is up to 1024 pairs
per DKC.
593
16 About Universal Replicator for Mainframe Operations