Fcu error codes for unix, Table 66 – HP XP P9500 Storage User Manual
Page 154
FCU Error Codes for UNIX
If the FCU for UNIX reports an error, use the Help-Error command to view the most recent error.
on page 154 lists and describes the FCU error codes for UNIX and provides instructions for resolving
each error condition. In
on page 154, the error codes marked by an asterisk (*) may also
be reported when I/O access contention for the Data Exchange volume occurs between the mainframe
and open-system hosts. If the cause of the error cannot be identified as described in
on page 154, check for any illegal I/O contention for the Data Exchange volume.
NOTE:
Error codes with a negative value are FCU errors. Error codes with a positive value are system errors.
UNIX system error codes are defined in the standard error file errno.h.
NOTE:
The error codes with (C) in the Error code cell in
on page 154 are generated only when using
with Data Exchange Code Converter. For details, see the
HP StorageWorks Data Exchange Code
Converter User's Guide.
Table 66 FCU Error Codes for UNIX
Recommended Actions
Error Message and Description
Error
Code
If you specified the parameter definition file
using the [param] option, make sure that the
specified file exists and the name is correct.
If you did not specify the [param] option when
you started the FCU, make sure that the default
parameter definition file exists
(fcudata.param in the current directory).
No parameter file
The FCU parameter definition file could
not be found.
-100
Display the system error code using the Help-
Error command. See the OS user manual for
information on system errors.
Parameter file: Open error
An error occurred when opening the
parameter definition file.
-101*
Display the system error code using the Help-
Error command. See the OS user manual for
information on system errors.
Parameter file: Read error
An error occurred when reading the
parameter definition file.
-102*
Make sure that the FCU initiation parameters
are entered correctly in the parameter definition
file.
Parameter file: No valid data
The parameters in the parameter
definition file are not valid.
-103*
Make sure that the code conversion is specified
as either EA or No.
Parameter file: CODE_CONV error
The code conversion specified in the
parameter definition file is not valid.
-107
Troubleshooting
154