HP XP Command View Advanced Edition Software - Manual (Page 278)

2. If this version is older than the prerequisite user SVC version of Smart Manager for Mainframe
after upgrading, disable (comment out) the
SYMDEF statement that contains the &YKSVCNO system
symbolic name in the IEASYMxx parmlib member, as shown below:
/* SYMDEF(&YKSVCNO='SVC-number') */
3. Disable (comment out) the SVCPARM statement that specifies the JYUASVC module of the
IEASVCxx parmlib member, as shown below:
/* SVCPARM SVC-number,REPLACE,TYPE(3),EPNAME(JYUASVC),APF(NO),NPRMPT(NO),AR(NO) */
To apply the deletion of the user SVC, perform re-IPL by specifying the CLPA parameter. Perform re-IPL
at the end of the preparation for upgrading.
CAUTION:
A user SVC is shared by Smart Manager for Mainframe and Business Continuity Manager. Therefore,
in a system where Business Continuity Manager is installed, make sure that Business Continuity
Manager is not running before deleting the user SVC.
Related topics
• Prerequisite user SVC versions for Smart Manager for Mainframe , page 57
• KTINSCHK , page 173
Removing the library linkage
Remove all the links to libraries that were established during setup.
Procedure
1. Remove the linkage of the HPQYPRCT cataloged procedure library.
• If the cataloged procedure library has been statically linked to the IEFPDSI DD name in the
MSTJCLxx parmlib member, remove the linkage.
• If the KTALCSVC , KTSETENV , and KTDSPENV members have been copied from the cataloged
procedure library to the user's PROCLIB, delete those members.
2. Remove the linkage of the HPQYLNKT load library for LINKLIB.
• If the load library for LINKLIB has been statically linked by adding it to the PROGxx parmlib
member, delete the load library from the member.
• If the load library for LINKLIB has been dynamically linked to LNKLST by using the SETPROG
LNKLST command, use the SETPROG LNKLST command to remove the linkage.
Upgrading Smart Manager for Mainframe 278