HP XP Command View Advanced Edition Software User Manual
Page 63
3.
Do either of the following:
• To specify an SMS storage group to be scanned:
Enter a slash (/) in the Storage Group field and specify the name of the target SMS storage
group. Then press the Scan function key (F6).
TIP:
If you perform either of the actions below without entering an SMS storage group name, the
Storage Group Selection List panel appears. You can use it to select the desired SMS storage
group from the list.
• Press the Scan function key (F6).
• Point the cursor to the entry field for the SMS storage group name, and then press Enter.
• To specify volumes to be scanned:
Enter a slash (/) in the Volser or Device Number field, specify the range of volumes to be
scanned in the Start and End fields, and then press the Scan function key (F6).
The numbers of detected storage systems and volumes are displayed in the Device Scan Scope
panel.
4.
Press the Exit function key.
The Confirm Configuration File Update panel appears. Confirm that you want to update the disk
configuration definition file.
5.
Press Enter.
The scan results are saved in the disk configuration definition file, and a list of scanned storage
systems appears in the Storage System List area.
TIP:
If the disk configuration changes significantly after the scan (for example, the storage systems
are replaced or the device numbers of volumes change due to changes in I/O definitions),
you must delete the disk configuration definition file. Then rescan the storage systems. If
necessary, define the tiering policy group again.
Postrequisites
•
Creating a tiering policy information CSV file
Related topics
• Creating a tiering policy information CSV file when using the ISPF panel
Creating a tiering policy information CSV file when using the ISPF panel
To create a tiering policy information CSV file, assign the policy ID to the file in the Policy CSV List
area in the main panel, and then edit the contents of the file.
User Guide
63