HP XP Command View Advanced Edition Software - Manual (Page 44)

2. After an IPL is performed again, use the KTDSPENV command to confirm that the system symbols
have been specified correctly.
START KTDSPENV,PARM='DETAIL'
Example of defining the IEASYMxx parmlib member
• When setting the name of the license information dataset to HPQ1.HPQ2.CCENTRAL.LICENSE
SYMDEF(&YKLCNSE='HPQ1')
SYMDEF(&YKLCNS2='HPQ2')
• When specifying whether to use the system logger service to collect event logs
SYMDEF(&YKLOGPT='LOGR') (if using the system logger service)
SYMDEF(&YKLOGPT='SAM') (if not using the system logger service)
• When specifying whether to output CLI command execution logs to SYSLOG
SYMDEF(&YKSYSLG='YES') (if outputting to SYSLOG)
SYMDEF(&YKSYSLG='NO') (if not outputting to SYSLOG)
TIP:
Use either the environment variables or the system symbols to specify both prefix-1 and prefix-2 .
If you use the environment variables to specify prefix-1 , and use the system symbols to specify
prefix-2 , the process of determining the prefixes will be complicated.
CAUTION:
System symbols are shared by Smart Manager for Mainframe and Business Continuity Manager.
Therefore, you must be careful when setting system symbols in an environment where Business
Continuity Manager is installed.
Postrequisites
• Settings required to use Smart Manager for Mainframe on the ISPF panel
Related topics
• Settings required to use Smart Manager for Mainframe on the ISPF panel , page 45
• Notes on setting environment variables or system symbols if Business Continuity Manager is in-
stalled , page 56
• KTDSPENV , page 177
• Collecting event logs , page 205
• Collecting the CLI command-execution log , page 219
Installation and setup 44