HP XP Command View Advanced Edition Software - Manual (Page 42)

Procedure
1. Execute the following KTSETENV command.
START KTSETENV,PARM='parameter=parameter-value'
2. Use the KTDSPENV command as follows to confirm that the environment variables have been
specified correctly:
START KTDSPENV,PARM='DETAIL'
Example of executing the KTSETENV command
• When setting the name of the license information dataset to HPQ1.HPQ2.CCENTRAL.LICENSE
START KTSETENV,PARM='YKLCNSE=HPQ1'
START KTSETENV,PARM='YKLCNS2=HPQ2'
• When specifying whether to use the system logger service to collect event logs
START KTSETENV,PARM='LOGPUT=LOGR' (if using the system logger service)
START KTSETENV,PARM='LOGPUT=SAM' (if not using the system logger service)
• When specifying whether to output CLI command execution logs to SYSLOG
START KTSETENV,PARM='SYSLOG=YES' (if outputting to SYSLOG)
START KTSETENV,PARM='SYSLOG=NO' (if not outputting to SYSLOG)
TIP:
This setting is invalidated if an IPL is performed again. Perform either of the following in caseyou need
to perform an IPL again the next time:
• Add the KTSETENV command to the COMMNDxx parmlib member to automatically set the envir-
onment variables when an IPL is performed again.
• For the IEASYMxx parmlib member, specify the system symbols so that the statically-registered
settings will be used the next time an IPL is performed.
TIP:
Use either the environment variables or the system symbols to specify both prefix-1 and prefix-2 .
If you use the environment variable to specify prefix-1 and use the system symbol to specify
prefix-2 , the process of determining the prefixes will be complicated.
Installation and setup 42