HP XP Command View Advanced Edition Software - Manual (Page 279)

3. If the user SVC has been registered by using the IEASVCxx parmlib member, remove the linkage
of the HPQYLPAT load library for LPALIB. (This step is unnecessary if the user SVC was registered
by using the YKALCSVC command.)
• If the load library for LPALIB has been statically linked by defining it in the LPALSTxx parmlib
member, delete the definition.
• If the load library for LPALIB has been dynamically linked to LPALST by using the
SETPROG
LPA command, use the SETPROG LPA command to remove the linkage.
To apply the removal of static linkages, you must perform re-IPL specifying the CLPA parameter.
Perform re-IPL at the end of the preparation for upgrading.
Upgrading Smart Manager for Mainframe
The procedure for upgrading Smart Manager for Mainframe is the same as for a new installation
except the following.
When upgrading Smart Manager for Mainframe:
• You do not need to register a user SVC if the currently enabled user SVC version satisfies the
conditions for the user SVC that are prerequisites for Smart Manager for Mainframe.
• If the license of the version before migration can be used and there are no licenses to be added,
you do not need to register a license for Smart Manager for Mainframe.
NOTE:
•
If a task requiring re-IPL was performed during preparation for upgrading, always perform re-IPL
before starting the procedure for upgrading.
• If sample JCL HPQKT2DF , which defines the distribution library and target library, terminated
abnormally during installation using SMP/E and GIM35601E ** DATASET SUBENTRY WAS
NOT ADDED BECAUSE IT ALREADY EXISTS. was output, change the ADD command in
HPQKT2DF to the REP command, and then execute HPQKT2DF again.
Related topics
• Chapter 2 , page 27
User Guide 279