HP XP Command View Advanced Edition Software - Manual (Page 32)

8. Re-execute HPQKT4AP after the CHECK operand is deleted.
SMP/E APPLY is executed and the provided datasets are installed in the target library.
Run the Smart Manager for Mainframe instance that was installed in the target library. If no errors
occur, back up Smart Manager for Mainframe to the distribution library.
The following table shows the keyword ( FMID ) that is required for installing with SMP/E.
Table 4 FMID for Smart Manager for Mainframe components
Function name FMID
Smart Manager for Mainframe CHKLnnn
Note:
The nnn part of CHKLnnn varies depending on the version.
Postrequisites
• Settings required for using CLI commands (registration for authentication)
Related topics
• Settings required for using CLI commands (registration for authentication) , page 33
• Backing up Smart Manager for Mainframe to the distribution library , page 54
• Appendix E , page 281
Installing directly from the provided datasets in the target library
Perform an installation directly from the provided datasets in the target library, without using SMP/E.
Procedure
1. Edit the sample JCL HPQKTSIN for installation in accordance with the user installation environment.
Details are provided at the beginning of the sample JCL.
The sample JCL is stored in the HP.CHKLnnn.F1 dataset (the nnn part varies depending on the
version). If you edited the RECVUPLD job to change the output destination dataset name for the
TSO/E
RECEIVE
command, the sample JCL is stored in the dataset after the change.
2. Execute HPQKTSIN .
The contents of the provided datasets are registered in the target library.
Postrequisites
• Settings required for using CLI commands (registration for authentication)
Related topics
• Settings required for using CLI commands (registration for authentication) , page 33
• Appendix E , page 281
Installation and setup 32