HP XP Command View Advanced Edition Software - Manual (Page 55)

BLKSIZE
(bytes) LRECL
(bytes)
RECFM DSORG Library type (DD name
#
)
6,160 80 FB PO
ISPF message library
(
HPQKMSGD )
6,160 80 FB PO
ISPF table library
(
HPQKTABD )
#
The DD name specified with the HPQKT1AL sample JCL (allocates the distribution and target lib-
raries) that was used when installing with SMP/E. The dataset name is the one specified in each
DD statement.
Related topics
• Performing an installation using SMP/E , page 31
• Appendix E , page 281
Notes on setting up Smart Manager for Mainframe when
Business Continuity Manager is already installed
This section provides notes on registering a user SVC and setting environment variables and system
symbols when installing Smart Manager for Mainframe in an environment where Business Continuity
Manager is installed.
Notes on registering a user SVC if Business Continuity Manager is installed
Smart Manager for Mainframe and Business Continuity Manager share the same user SVC. Therefore,
you must compare the version of the currently enabled user SVC registered by Business Continuity
Manager and the version of the prerequisite user SVC for Smart Manager for Mainframe, and then
you must use the user SVC of the later version.
To confirm the version of the currently enabled user SVC, use the YKINSCHK command of Business
Continuity Manager.
• If the confirmed user SVC version is old and does not satisfy conditions for the prerequisite user
SVC version requirement of Smart Manager for Mainframe:
Use Business Continuity Manager to delete the user SVC, and then use Smart Manager for Main-
frame to register it again.
• If the confirmed user SVC version satisfies conditions for the prerequisite user SVC version:
You can use the currently enabled user SVC as it is.
User Guide 55