HP 3PAR Recovery Manager Software - Manual (Page 58)

copy at the secondary site. If not specified, the wait time is 120
seconds by default.
-rc <target server> Remote Copy target server. To use this option, the Recovery
Manager Backup Component server, with HP 3PAR Recovery
Manager for Microsoft SQL Server installed, must be located at the
secondary site.
-noemail Optional. Do not send an email notification even if configured for
this operation. If not specified, Recovery Manager sends an email
notification of the virtual copy creation if configured. For more
information, see Configuring Email Notifications.
-exp <time>{h|H|d|D} Optional. Set the expiration time for this virtual copy to the specified
time and time unit. Valid values are:
•
To set the expiration time in hours: 1-43800h (or H)
•
To set the expiration time in days: 1-1825d (or D)
•
To remove the expiration period: 0h (or 0H) or 0d (or 0D)
To use this option, the HP 3PAR Recovery Manager for SQL policy
must be set to an expiration-based policy.
If not specified, HP 3PAR Recovery Manager for SQL creates the
virtual copy using the expiration time specified in the current policy.
NOTE: During remote virtual copy creation for periodic mode,
the expiration time set at the secondary backup server is used as
the time based policy. The policy set at the primary backup server
is ignored. In case of synchronous mode, the expiration value is
applied to both, the local virtual copy and remote virtual copy.
Remote virtual copy creation cannot be done if primary backup
server and secondary backup server for different values are set for
expiration at synchronous mode.
-retain
<time>{h|H|d|D}
Optional. Set or extend the retention time for the specified virtual
copy to the specified time. The virtual copy cannot be removed
during this time period.
58 Using the Recovery Manager CLI