HP Integrity NonStop H-Series - Manual (Page 171)

Cause
One or more of the command parameters were invalid.
Effect
The command fails to execute.
Recovery
Specify valid parameter and restart the application. See Section 8, FTP API External Specification
for valid parameters.
424 Unable to get startup message
Cause
The application program using the FTP API failed to get the startup message to send to the FTP
Client Process.
Effect
The FTP session is not created.
Recovery
Restart the application
TELNET Error Messages
This subsection describes the TELNET error messages.
Ambiguous mode mode ('mode ?' for help)
Cause
The mode you specified does not contain enough characters to identify it clearly.
Effect
The command is ignored.
Recovery
Enter the command again, but specify enough characters to identify it clearly as either character
mode or line mode.
Can't open terminal
Cause
TELNET could not open your home terminal on the remote system.
Effect
You are not connected to the remote system.
Recovery
Make sure you have specified the host name or address correctly. If the TELNET port is not 23,
specify the port number.
Can't setmode number on term err error-number
Cause
TELNET cannot set the mode you specified due to the error specified by error-number.
Effect
The mode is not set.
Recovery
See
“Recovering From Errors” (page 162) .
Can't turn off/on crmod err error-number
Cause
An error occurred when TELNET tried to switch modes from line-to-character or character-to-line.
TELNET Error Messages 171