HP Integrity NonStop H-Series - Manual (Page 88)

Next, start FTP and open a connection to the desired FTP server using its IPv6 address. Then, issue
the stru r command. Using the information highlighted in the above example, issue the FTP put
command, then issue the stru f command:
\IDC15.$FITI.FTPMARCH 91> ftp fe80::a00:8eff:fe01:7db8
\IDC15.$FITI.FTPMARCH 91..
FTP Client - T9552G07 - (01MAY2003) - COPYRIGHT TANDEM COMPUTERS
INCORPORATED 2003
Connecting to fe80::a00:8eff:fe01:7db8.........Established.
220 idc15.wipro.tcpn.com FTP SERVER T9552G07 (Version 3.r TANDEM
01MAY2003) ready.
Name (fe80::a00:8eff:fe01:7db8:user): super.super
331 Password required for SUPER.SUPER.
Password:
230 User SUPER.SUPER logged in. GUARDIAN API enabled
ftp> cd $fiti.remote
250 CWD command successful.
ftp> lcd $fiti.q9552d
Local working vol.subvol: "\IDC15.$FITI.Q9552D"
ftp> stru r
200 STRU R ok.
ftp> put $fiti.q9552d.PERFK0 keyseq,k,1001,6,6,4000,4,0,4096
200 EPRT command successful.
150 Opening data connection for keyseq (fe80::a00:8eff:fe01:7db8,1349d).
226 Transfer complete.
local: $fiti.q9552d.PERFK0 remote: keyseq
4020000 bytes sent in 12.52 seconds (313.56 Kbytes/s)
ftp> stru f
200 STRU F ok
sunique
Use the sunique command to turn on or off a mechanism that the FTP server uses to create unique
names for files copied to the remote system. The sunique command operates as a toggle.
sunique
The sunique mechanism ensures that operations complete even though a naming conflict occurs.
If sunique is on, the FTP server uses a scheme for assigning a unique name. Each server determines
its own scheme.
The FTP server must support the FTP-protocol STOU command in order for sunique to operate
properly. (You can use the remotehelp command to check whether the server supports STOU.)
If the operation is successful, the FTP server reports the unique name it creates.
When you start an FTP session, sunique is off.
Example
To change the setting of sunique, enter the following command:
ftp> sunique
Store unique on.
tenex
Use the tenex command to set the data representation type to that required to communicate with
TENEX machines (a local logical byte size of 8 bits).
tenex
Example
The following command sets the data type to tenex:
ftp> tenex
88 FTP—Transferring Files