HP Integrity NonStop H-Series - Manual (Page 178)

Cause
The get or put command you entered is not correct. (The host name does not appear if the
connection has been established.)
Effect
The transfer operation fails.
Recovery
Make sure that you are using the correct command syntax and specifying valid host and file
names.
usage: [rexmt/timeout] value
Cause
You have not specified a value with a rexmt or timeout command.
Effect
The command is ignored.
Recovery
Enter the command again and specify a positive number.
usage: tftp host-name [port]
Cause
You have entered an invalid RUN command.
Effect
The command interpreter prompt appears.
Recovery
Check the syntax of the TFTP RUN command and enter the command again. Make sure that you
specify valid parameters in the correct order.
value-given: bad value
Cause
You specified an improper value in the rexmt command.
Effect
The command is ignored.
Recovery
Enter the command again with the correct value. You cannot enter a negative number.
TFTP Server Error Messages
These error messages appear on the operator’s screen. They are also logged to $0.
Bringing down TFTPSRV...
Cause
The Server terminates because of an exceptional condition. This message is always preceded
by an EMS message describing the exceptional condition.
Effect
The server terminates.
Recovery
Take the recommended action for the condition as described in the EMS message.
Child Process Create Err error-number, Err-detail
error-detail
Cause
Creation of the TFTPCHLD process failed.
178 Error Messages