HP Photosmart C8180 All-in-One Printer - Manual (Page 47)

Related topics
“View and print network settings” on page 41
Network configuration page definitions
The network configuration page shows the network settings for the HP All-in-One. There
are settings for general information, 802.3 wired (Ethernet), 802.11 wireless, and
Bluetooth
® .
This section contains the following topics:
• General network settings
• Wired (802.3) network settings
• Wireless (802.11) network settings
• Bluetooth settings
Related topics
• “View and print network settings” on page 41
• “Network glossary” on page 52
General network settings
The following table describes the general network settings shown on the network
configuration page.
Parameter Description
Network Status Status of the HP All-in-One:
• Ready: The HP All-in-One is ready to receive or transmit data.
• Offline: The HP All-in-One is not currently connected to the network.
Active connection
type Network mode of the HP All-in-One:
• Wired: The HP All-in-One is connected by Ethernet cable to an IEEE
802.3 network.
• Wireless: The HP All-in-One is connected to a wireless (802.11) network.
• None: There is no network connection.
URL The IP address of the Embedded Web Server.
NOTE: You will need to know this URL when you try to access the
Embedded Web Server.
Firmware
Revision The internal networking component and device firmware revision code.
NOTE: If you call HP Support, depending on the problem, you might be
asked to provide the firmware revision code.
Hostname The TCP/IP name assigned by the installation software to the device. By
default, this is the letters HP followed by the last 6 digits of the Media Access
Control (MAC) address.
Chapter 4
46 Finish setting up the HP All-in-One
Finish set
up