HP LaserJet M9040M9050 Multifunction Printer series - Manual (Page 42)

Menu item Sub-menu item Sub-menu item Values and Description
Address Use this item to manually configure an IPv6 address.
Manual Settings : Use the Manual Settings menu to
enable and manually configure a TCP/ IPv6 address.
DHCPV6 Policy
Router Specified (Default): The stateful auto-
configuration method to be used by the print server is
determined by a router. The router specifies whether
the print server obtains its address, its configuration
information, or both from a DHCPv6 server.
Router Unavailable : If a router is not available, the print
server should attempt to obtain its stateful
configuration from a DHCPv6 server.
Always : Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
Primary DNS Use this item to specify an IPv6 address for a primary
DNS server that the print server should use.
Manual Settings Use this item to manually set IPv6 addresses on the
print server.
Enable : Select this item and choose On to enable
manual configuration, or Off to disable manual
configuration.
Address : Use this item to type a 32 hexadecimal digit
IPv6 node address that uses the colon hexadecimal
syntax.
Proxy Server Specifies the proxy server to be used by embedded
applications in the device. A proxy server is typically
used by network clients for Internet access. It caches
Web pages, and provides a degree of Internet security,
for those clients.
To specify a proxy server, enter its IPv4 address or
fully-qualified domain name. The name can be up to
255 octets.
For some networks, you may need to contact your
Independent Service Provider (ISP) for the proxy
server address.
Proxy Port Type the port number used by the proxy server for
client support. The port number identifies the port
reserved for proxy activity on your network, and can be
a value from 0 to 65535.
IPX/SPX Enable Off : Disable the IPX/SPX protocol.
On (default): Enable the IPX/SPX protocol.
Frame Type Selects the frame-type setting for your network.
Auto (Default): Automatically sets and limits the frame
type to the first one detected.
EN_8023 , EN_II , EN_8022 , and EN_SNAP : Frame-
type selections for Ethernet networks.
Table 2-10 Jetdirect menus (continued)
28 Chapter 2 Control panel ENWW