HP Tower Uninterruptible Power System - Manual (Page 20)

HP T750 G2, HP T750J, HP T1000 G3, HP T1000J, HP T1500 G3, and HP T1500J UPS Models User Guide S 505922-002 13
Chapter 5 Additional UPS Features
This section describes:
S
Voltage configuration
S USB port and serial port
S
Network transient protector
S HP Power Manager software
Voltage Configuration
The DIP switches on the rear panel of each unit (see Figure 14) are used to configure
the output voltage and input voltage range.
To configure voltage:
1 The UPS must be completely shutdown.
To turn off the UPS, press and hold the (On/Off) button for two seconds and
then unplug the UPS from the power outlet.
2 Set the DIP switches according to the configurations in Table 1 on page 14.
3 Plug the UPS power cord into a power outlet.
4 Press and hold the (On/Off) button until you hear the UPS beep to turn the UPS
on.
UPS Rear Panel
ON
OFF
2 1
Figure 14 DIP Switches