HP Officejet Pro 8600 - Manual (Page 124)

Figure 9-1 Back view of the printer
1
2
1 Telephone wall jack
2 Use the phone cord supplied in the box with the printer to connect to the "1-
LINE" port
2. After you have connected the phone cord to the port labeled 1-LINE, run the
fax test again to make sure it passes and the printer is ready for faxing.
3. Try to send or receive a test fax.
• Make sure you use the phone cord that came with the printer. If you do not
use the supplied phone cord to connect from the telephone wall jack to the
printer, you might not be able to send or receive faxes. After you plug in the
phone cord that came with the printer, run the fax test again.
• If you are using a phone splitter, this can cause faxing problems. (A splitter
is a two-cord connector that plugs into a telephone wall jack.) Try removing
the splitter and connecting the printer directly to the telephone wall jack.
The "Using Correct Type of Phone Cord with Fax" test failed
Solution:
•
Make sure you used the phone cord supplied in the box with the printer to
connect to the telephone wall jack. One end of the phone cord should be
Chapter 9
120 Solve a problem