HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 35)

Command line 35
Item Description
set fcoe-connection Modify an existing FCoE connection.
Syntax
set fcoe-connection <ConnectionID> [Fabric=<FabricName>]
[SpeedType=<1Gb|2Gb|4Gb|8Gb|Custom|Disabled>]
[CustomSpeed=<100Mb-10Gb>] [BootPriority=<priority>]
[BootPort=<portName>] [BootLun=<LUN>]
Parameters
ConnectionID
(required)
The ID of an existing FCoE connection. The ID format is <ProfileName:Port>.
Properties
Fabric (optional) The name of the FCoE SAN fabric to associate with the connection. The fabric
being specified should be associated with the same bay as the FC connection.
SpeedType (optional) The requested operational speed for the server. Valid values include
"1Gb","2Gb", "4Gb", "8Gb", "Custom", and "Disabled". If the SpeedType is
Custom, the user can configure any speed from 100Mb to 10Gb in 100Mb
increments.
CustomSpeed (required
if the SpeedType is
Custom)
The user-defined speed for the server port. Valid values include 100Mb to
10Gb configured in 100Mb increments.
BootPriority
(optional)
Controls whether the FCoE HBA port is enabled for SAN boot and affects the
BIOS boot order. Valid values include "BIOS", "Primary", "Secondary", and
"Disabled".
BootPort
(Required if the Boot Priority is
either Primary or
Secondary)
The target WWPN of the controller interface on the Fibre Channel storage
target. The port name is a 64-bit identifier in the format
NN:NN:NN:NN:NN:NN:NN:NN, where N is a hexadecimal number.
BootLun
(Required if the Boot Priority is
either Primary or
Secondary)
The LUN of the volume used for SAN boot. Valid values include an integer from
0 to 255 or 16 hex digits (HP-UX only).
Examples
->set fcoe-connection MyProfile:1 Fabric=SAN_5
Changes the fabric of an FCoE SAN fabric connection
->set fcoe-connection RedProfile:2 Fabric=""
Sets a FCoE SAN fabric connection to "Unassigned"
->set fcoe-connection MyProfile:1 SpeedType=Custom
CustomSpeed=5000
Modifies the FCoE connection and sets the speed to 5Gb
->set fcoe-connection BlueProfile:1 BootPriority=Primary
BootPort=50:06:0B:00:00:C2:62:00 BootLun=5
Changes the SAN boot priority and sets additional boot parameters
Item Description
show fcoe-connection Display the FCoE connections associated with the server profiles.
Syntax
show fcoe-connection [<ConnectionID>]