HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 38)

Command line 38
Item Description
interconnect bay number 5
->show interconnect enc0:*
Displays interconnect modules in all bays of a specific enclosure
->show interconnect enc0:3
Displays detailed information on a specific interconnect module in interconnect
bay 3 of the primary enclosure
iscsi-boot-param
Manage iSCSI boot parameters within a domain.
Supported actions: help, remove, set, show
Item Description
remove
iscsi-boot-param
Remove all iSCSI boot parameters configured on the specified iSCSI
connection.
Syntax
remove iscsi-boot-param <ConnectionID>
Parameter
ConnectionID
(required)
The ID of an existing iSCSI connection. The ID format is <ProfileName:Port>. To
retrieve the port number of the iSCSI connection, use the show profile
<ProfileName> command.
Example
->remove iscsi-boot-param MyProfile1:1
Removes boot parameters configured on connection 1 of MyProfile1
Item Description
set iscsi-boot-param Configure the basic iSCSI boot parameters on the specified iSCSI connection.
Syntax
set iscsi-boot-param <ConnectionID> [-maskSecret]
[-maskMutualSecret]
[BootOrder=<Primary|Secondary|Disabled|USE-BIOS>]
[LUN=<Logical Unit number>] [InitiatorName=<Initiator
name>] [InitiatorIP=<IP address>] [Mask=<Netmask>]
[Gateway=<Gateway>] [VlanID=<Vlan Id>]
[TargetName=<Target Name>] [TargetIP=<Primary Target IP>]
[TargetPort=<Primary Target Port>] [TargetIP2=<Alternate
Target IP>] [TargetPort2=<Alternate Target Port >]
[Authentication=<None|CHAP|CHAPM>] [Username=<username>]
[Secret=<secret password>] [MutualUsername=<username>]
[MutualSecret=<Mutual secret password>]
[iSCSIParamDHCP=<Enabled|Disabled>]
[NetworkParamDHCP=<Enabled|Disabled>]
[DHCPVendorID=<VendorID>]
Parameter
ConnectionID
(required)
The ID of an existing iSCSI connection. The ID format is <ProfileName:Port>. To
retrieve the port number of the iSCSI connection, use the show profile
<ProfileName> command.
Options
maskSecret (optional) Enables the user to interactively specify the CHAP secret as a masked string at
the command prompt
maskMutualSecret
(optional)
Enables the user to interactively specify the mutual CHAP secret as a masked
string at the prompt