Creating tse-vols – HP XP P9500 Storage User Manual
Page 94
8.
Click Option.
9.
In the Initial Pool ID text box, enter a number from 0 through 127.
The smallest available non-zero number appears in the text box by default. No number appears
in the text box if no available pool ID exists. When the registered pool ID is entered, the
smallest available pool ID is registered.
10. In the Subscription Limit text box, enter an integer value from 0 to 65534 as the subscription
rate (%) for the pool. The Subscription Limit defines a limit of how much capacity can be
defined in the pool compared to the actual pool capacity. A value of 1000% means that the
defined thin-provisioned volumes for the pool will be limited to ten times the installed capacity
of the pool volumes defined.
If no subscription limit is entered, the subscription rate is set to unlimited.
11. In the Warning Threshold text box, enter an integer value from 1 to 100 as the rate (%) for
the pool. The default value is 70%.
12. In the Depletion Threshold text box, enter an integer value from 1 to 100 as the rate (%) for
the pool. The default value is 80%.
Enter the value more than the value of Warning Threshold.
13. Click Add.
The created pool is added to the right Selected Pools table. If an invalid value is set, an error
message appears.
Values for all required items must be entered or selected before you click Add. Required items
are marked with an asterisk (*) and include Pool Type, Pool Volume Selection, and Pool Name.
14. Click Next.
The Create LDEVs window appears. Go to
to create TSE-VOL.
If the pool ID is an even number, you can only create TSE-VOL that has a CU# value that is
an even number. If the pool ID is an odd number, you can only create a TSE-VOL that has
CU# value that is an odd number.
If the Subscription Limit for all of the created pool is set to 0%, the Create LDEVs window does
not appear.
To finish the wizard, click Finish. The Confirm window appears.
15. In the Confirm window, click Apply to register the settings.
If the Go to tasks window for status check box is selected, the Tasks window appears.
Creating TSE-VOLs
You can create TSE-VOLs from any of the following tabs:
•
The LDEVs tab, which appears when Logical Devices is selected.
•
The Pools tab, which appears when Pools is selected.
•
The Virtual Volumes tab, which appears when a pool in Pools is selected.
94
Performing Compatible FlashCopy SE operations