HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 133)

Virtual Connect networks 133
Field name Description
more information about possible causes, see "Port status conditions (on
page 261 )."
ConnectorType The type of connector on the port; for example, RJ-45
Connected To If the individual port is connected to a switch that supports LLDP, the switch
LLDP system name or management IP address and switch port number
appear. A link is provided to obtain more information about the far-end
switch port.
PID PID status icon (on or off) for the port
Speed/Duplex Pull-down menu to specify the speed and duplex (where applicable) of the
uplink port. Half-duplex operations are not supported by the VC-Enet
module. For shared uplink sets using an associated FCoE network, the
Speed/Duplex is always Auto.
Action Perform delete operations
Associated FCoE Network (VLAN
tagged)
Allows addition of FCoE network. See "Defining an FCoE network (on page
129 )."
Network Name Displays the name of the associated FCoE network
VLAN ID Displays the VLAN ID number
Associated Networks (VLAN
tagged)
Network Name Displays the name of the associated networks
VLAN ID Displays the VLAN ID number
Native Select whether native VLAN is enabled (checked) or disabled (unchecked).
Smart Link Select whether Smart Link is enabled (checked) or disabled (unchecked).
Private Network Select whether to designate (checked) or not designate (unchecked) the
network as a private network.
Action Perform edit and delete operations
Connection Mode Connection mode of the uplink ports for this network. For a description of the
connection modes, see "Defining a shared uplink set." This mode cannot be
changed for shared uplink sets using an associated FCoE network.
LACP Timer Applicable if Connection Mode is Auto. Shows the LACP timer configuration
for this network. This setting controls the requested frequency of LACP control
messages on a LACP capable interface. The domain default option shows
the current default.
The following table describes the available actions in the Edit Shared Uplink Set screen. Clicking another link
in the pull-down menu or left navigation tree causes current edits that have not been applied to be lost.
Task Action
Rename shared uplink set Click on the uplink set name and edit. Click Apply.
Add an external port Use the cascading menu to select a port.
Set the Port Role to primary or
secondary Click the down arrow in the Port Role column and select Primary or
Secondary. Only available if the connection mode is set to Failover. This
setting cannot be changed for shared uplink sets with an associated FCoE
network.
Change the uplink interface port
speed or disable a port
Click the pull-down box under Speed/Duplex, and then select a setting. For
shared uplink sets with an associated FCoE network, this settings is always
Auto.
Delete a port Click the Delete link in the Action column, or left-click to select a port,
right-click to display a menu, and then select Delete Port.