HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 156)

Virtual Connect fabrics 156
Task Action
Edit a SAN fabric
Click the Go To Fabric link in the Action column, or highlight the desired
SAN, right-click, and then select Go To Fabric.
Edit a profile If necessary, click the + next to the fabric name to expand the information.
Click the Go To Profile link in the Action column, or highlight the desired
profile row, right-click, and then select Go To Profile.
Redistribute logins For FabricAttach connections with Manual login redistribution, highlight
the desired SAN, click the down arrow next to the Go To Fabric link in the
Action column, and then select Redistribution Logins or highlight the
desired SAN, right-click, and then select Redistribute Logins.
Fibre Channel Settings (Misc.) screen
Automatic Login Redistribution is an advanced option that can be enabled for a Virtual Connect fabric that
is located on a FlexFabric module. You can configure the link stability interval parameter on a VC domain
basis. This interval defines the number of seconds that the VC fabric uplink(s) have to stabilize before the
FlexFabric module attempts to load balance the logins.
Access this screen in one of the following ways:
• Click WWN Settings under Fibre Channel Settings in the left navigation tree, and then click the Misc.
tab.
• Select Fibre Channel Settings from the Configure pull-down menu, and then click the Misc. tab.
If you define FC fabrics a FlexFabric module and choose the advanced option for automatic redistribution,
you can set the time interval to wait after a link becomes stable before automatic redistribution occurs within
the fabric. The interval can be between 1 and 1800 seconds, in 1-second increments. Set the interval to the
preferred value, and then click Apply. The same interval applies to all Virtual Connect fabrics with automatic
redistribution chosen. The default value is 30 seconds.