HP Color LaserJet CP3505 Printer series - Manual (Page 157)

Control panel message Description Recommended action
See Supplies and accessories on page 181
for more information.
REPLACE SUPPLIES
alternates with
To continue press
More than one supply item is low, and the
REPLACE SUPPLIES setting in SYSTEM
SETUP is set to STOP AT LOW. 1. Press Menu and navigate to the
SUPPLIES STATUS menu in order to
identify which supplies should be
ordered.
2. Order the supplies.
3. Press to continue printing.
See Supplies and accessories on page 181
for more information.
REPLACE SUPPLIES
Override in use
alternates with
Ready
At least one print cartridge is out, but printing
is continuing. Print-quality problems might
occur. 1. Press to identify which supplies
should be ordered.
2. Order the identified supplies.
See Supplies and accessories on page 181
for more information.
REPLACE SUPPLIES
Using black only
alternates with
Ready
At least one color print cartridge is out.
Printing can continue, but only the black
cartridge is being used. 1. Press to identify which supplies
should be ordered.
2. Order the identified supplies.
See Supplies and accessories on page 181
for more information.
Request accepted please wait The printer has accepted a request to print an
internal page, but the current job must finish
printing before the internal page will print. No action necessary.
Resend upgrade The firmware upgrade was not successful. Attempt the upgrade again.
Restoring factory settings The printer is restoring factory settings. No action necessary.
Restoring... The printer is restoring settings. No action necessary.
RESTRICTED FROM PRINTING IN COLOR
alternates with
Ready
The message appears when the printer is set
to COLOR IF ALLOWED and you or your
software program are not authorized to print
in color. Get your network administrator to set the user
or program permissions that will allow you to
print in color.
RFU LOAD ERROR An error has occurred during a firmware
upgrade. 1. Reinstall the firmware.
2. If the problem persists, contact
HP Support.
Rotating <COLOR> motor
alternates with
To exit press STOP key
A component test is in progress; the
component selected is <color> Cartridge
motor. Press Stop to stop this test.
Rotating motor
alternates with
To exit press STOP key
The printer is testing a motor. Press Stop to stop this test.
ENWW Control-panel messages 145