HP Color LaserJet CP3505 Printer series - Manual (Page 67)

Network configuration
The HP Color LaserJet CP3505n, CP3505dn, and CP3505x models support network connections. The
network port is on the right side of the printer.
Connect the network cable
Plug the network cable into the printer.
Figure 5-2 Network port connection
1
2
1 Network port
2 Network cable
Configure the network product
You might need to configure certain network parameters on the printer. You can configure these
parameters from the printer control panel, the embedded Web server, or for most networks, from the
HP Web Jetadmin software.
NOTE: For more information about using the embedded Web server, see Use the embedded Web
server on page 113 .
For a complete list of supported networks and for instructions on configuring network parameters from
software, see the HP Jetdirect Embedded Print Server Administrator’s Guide. The guide comes with
printers in which an HP Jetdirect embedded print server is installed.
Manually configure TCP/IP parameters from the printer control panel
Use manual configuration to set an IP address, subnet mask, and default gateway for an IPV4 network
card.
Set the IP address
1. Press Menu .
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight I/O, and then press .
4. Press to highlight EMBEDDED JETDIRECT, and then press .
5. Press to highlight TCP/IP, and then press .
6. Press to select IPV4 SETTINGS.
7. Press to select CONFIG METHOD.
ENWW Network configuration 55