HP StorageWorks XP Remote Web Console Software - Manual (Page 106)

Table 33 Cause of Error and the Result of RAID Manager Command (SSB) (continued)
Cause of Error RAID Manager Command SSB2 SSB1
paircreate,
pairsplit,
pairresync,
pairresync -
pairresync -
Since you specified the
volume that is in process of
formatting as the XP
Snapshot P-VOL, the
command ends abnormally. paircreate,
pairsplit,
pairresync,
pairresync -
pairresync -
9728
Since you specified the
volume whose emulation
type is other than OPEN-V
as the XP Snapshot P-VOL,
the command ends
abnormally. paircreate,
pairsplit,
pairresync,
pairresync -
pairresync -
9729
Since the volume you
specified as the XP Snapshot
P-VOL has the command
device setting, the pair
cannot be created. paircreate 972a
Since the capacity of the
volume you specified as the
XP Snapshot P-VOL exceeds
the supported size (4TB), the
pair cannot be created. paircreate 972c
Since the capacity of the
volume you specified as the
XP Snapshot S-VOL exceeds
the supported size (4TB), the
pair cannot be created. paircreate 972e
Since you specified a V-VOL
as the XP Snapshot P-VOL,
the pair cannot be created. paircreate 972f
Since you specified a
pool-VOL as the XP Snapshot
P-VOL, the pair cannot be
created. paircreate 9730
When XP Snapshot P-VOL
and XP Continuous Access
Software P-VOL share the
volume, the status of the XP
Continuous Access pair is
other than PSUS or PSUE.
Therefore, the XP Snapshot
pair cannot be restored. pairresync -
restore
9731
pairresync -
restore
9732
106 Troubleshooting