HP StorageWorks XP Remote Web Console Software - Manual (Page 72)

To change the threshold of the pool:
1. Change the mode of the Remote Web Console to Modify.
If the mode is already changed to Modify, you can skip this step. For information on how to
change the mode, see the HP StorageWorks XP24000/XP20000 Remote Web Console User
Guide.
2. Select and right-click the pool whose setting you want to change in the Pool tree of the Pool
window. A menu appears. If the pool usage rate is 95% or higher, the menu will not be
displayed.
3. Select the Change Pool Information command from the menu. The Change Pool
Information dialog box (
Figure 16 (page 72) ) appears.
4. Select the value for the threshold from the Threshold drop-down list.
In the drop-down list, only the values that are higher than the pool usage rate are displayed.
5. Click OK.
The Change Pool Information dialog box closes.
6. Click Apply.
The confirmation message indicating if it is OK to apply the setting to the storage system is
displayed.
7. Click OK.
The confirmation message closes and the change of the setting is applied to the subsystem.
Figure 16 Change Pool Information Dialog Box
The items in the Change Pool Information dialog box are the same as those of the New Pool dialog
box. However, in the Change Pool Information dialog box, you cannot enter or select items other
than the Threshold drop-down list.
Deleting Pools
Usually, you specify one pool and delete only the specified pool. However, you may delete multiple
pools at the same time, if necessary. This section describes the procedures for when you delete
one specified pool and when you delete multiple pools at the same time.
Deleting a Pool
To delete a pool:
1. Change the mode of the Remote Web Console to Modify.
If the mode is already changed to Modify, you can skip this step. For information on how to
change the mode, see the HP StorageWorks XP24000/XP20000 Remote Web Console User
Guide.
72 Performing XP Snapshot Operations