HP ProLiant DL380 G4 Server - Manual (Page 56)

Hardware options installation 56
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power
supply or power supply blank to cool before touching it.
3. Slide the power supply into the power supply bay.
4. Connect the power cord to the power supply.
5. Route the power cord through the cable management arm or power cord anchor.
NOTE: If using the power cord anchor, be sure to leave enough slack in the power cord so that the
redundant power supply can be removed without disconnecting the power cord from the primary power
supply.
6. Reposition the cable management arm into the operating position.
7. Connect the power cord to the power source.
8. Be sure that the power supply LED is green (" Rear panel LEDs and buttons " on page 11 ).
9. Be sure that the front panel external health LED is green (" Front panel LEDs and buttons " on page 9 ).
PCI riser cage options
Installing the PCI riser cage
CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all
AC power cords before removing or installing the PCI riser cage.