HP StorageWorks XP Remote Web Console Software - Manual (Page 28)

Figure 10 Copying All Datasets Using the COPY FULL Command (Version 1)
The following conditions cause the storage system to output the ADR935W message, and end with
CC = 4 (copy operation is performed via the host):
•
The size of the T-VOL is larger than the S-VOL within the same CU image.
•
The emulation types of the S-VOLs and T-VOLs are different within the same CU image.
When the SSID boundary is 64 LDEV and you establish a relationship between two volumes that
have the same CU image but different SSIDs, copy data from S-VOL to T-VOL using the host program.
Releasing a Version 1 Relationship Using FCWITHDR
Use the FCWITHDR command of PPRC TSO to release a Version 1 relationship. The specified
volume must have an established relationship.
When the SSID boundary is 64-LDEV, the S-VOL and the T-VOL for Version 1 must be established
in the same CU image and SSID. When the S-VOL and the T-VOL are in different CUs or different
SSIDs, delete the relationship from the ShadowImage for Mainframe Pair Operation window.
“Parameters for the FCWITHDR Command (Version 1)” (page 28) lists the parameters you can use
with the FCWITHDR command.
Table 18 Parameters for the FCWITHDR Command (Version 1)
Description Value Parameter
Specify the number (device address) of
the S-VOL on which you want to
perform the FCWITHDR command. Source device number. SDEVN
Specify the number (device address) of
the T-VOL on which you want to
perform the FCWITHDR command. Target device number. TDEVN
“FCWITHDR Command” (page 29) shows an example of the FCWITHDR command.
28 Performing Version 1 Operations