HP Insight Control User Manual
Page 115
contained in other active volumes, but the partitions do not need to be migrated. The operating system
must be stored on the boot disk and loaded using NT Boot Loader (NTLDR).
Volumes on dynamic disks are migrated to partitions on basic disks. Volumes that span multiple dynamic
disks (including spanned, striped, mirrored, and RAID 5 volumes) are migrated to a single contiguous
partition. Volumes stored on a common source disk must also be stored on a common destination disk.
You can resize only NTFS partitions.
The Computed Destination Server Disk Requirement section lists the disks required on the destination
server to support migrated volumes. Insight Control server migration updates the Size, Minimum
Destination Size
, and Maximum Destination Size values in the lower table dynamically as volumes
in the upper table are selected or cleared for migration. A message appears under the table, indicating
the number of logical units that you must create on the destination server. The entry in the Minimum
Destination Size
column is estimated, based on reducing eligible volumes to their minimum size during
migration. Additional space might be required to accommodate disk geometry differences. Verify the
destination server disks are prepared to support the selected partitions.
5.
Enter the VM Host Name or four-part VM Host IP Address for the destination virtual machine host.
Select the appropriate destination virtualization layer in the Select Virtualization Layer box.
•
If the destination virtual machine was manually created and booted with the Insight Control server
migration Virtual Machine Boot CD, select Manual Boot - Manually create VM through VM
Host's Infrastructure Client
. Enter the four-part IP address of the destination virtual machine,
and then click Next.
The Virtual Machine Boot CD can be found at <installation
directory>\webserver\webapps\smpui\smpbootcd-v-6.0.0.0.iso
. The Virtual
Machine Boot CD is also available in the SMP folder on the Insight Control server migration CD.
For more information about manually booting a virtual machine with the Insight Control server
migration Virtual Machine Boot CD, see
Prerequisites for manually creating and booting a
Virtual-to-virtual (V2V) migrations for Windows
115