HP Insight Control - Manual (Page 126)

The Computed Destination Server Disk Requirement section lists the disks required on the destination
server to support migrated volumes. Insight Control server migration updates the Size values in the
lower table dynamically as volumes in the upper table are selected or cleared for migration. A message
appears under the table, indicating the number of logical units that you must create on the destination
server. Additional space might be required to accommodate disk geometry differences. Verify the
destination server disks are prepared to support the selected partitions.
5. Enter the VM Host Name or four-part VM Host IP Address for the destination virtual machine host.
Select the appropriate destination virtualization layer in the Select Virtualization Layer box.
•
If the destination virtual machine was manually created and booted with the Insight Control server
migration Virtual Machine Boot CD, select Manual Boot - Manually create VM through VM
Host's Infrastructure Client
. Enter the four-part IP address of the destination virtual machine,
and then click Next.
The Virtual Machine Boot CD can be found at <installation
directory>\webserver\webapps\smpui\smpbootcd-v-6.0.0.0.iso
. The Virtual
Machine Boot CD is also available in the SMP folder on the Insight Control server migration CD.
For more information about manually booting a virtual machine with the Insight Control server
migration Virtual Machine Boot CD, see
Prerequisites for manually creating and booting a
destination virtual machine .
NOTE: Static certificates are used when the destination server is booted manually using the Insight
Server Migration software for ProLiant Boot CD; however, dynamic certificates are generated and
used when the destination server is booted automatically from the application station, using the
126 Using Insight Control server migration to migrate servers