Configuring the switch (key steps) – HP 3Gb SAS Switch for HP BladeSystem c-Class User Manual

Page 17

Advertising
background image

Configuring the switch (key steps)

After physically installing the switch (or switches) in the BladeSystem c-Class enclosure and cabling
them to external SAS storage enclosures, do the following to initially configure the switches:

1.

Go to the Maintain tab and enter all switch parameters. Key tasks include:

•

Enter network settings

•

Enter SNMP settings

•

Update switch firmware (if needed).

•

Update storage enclosure firmware (if needed).

2.

Go to the Zoning tab and create zone groups and assign them to server device bays. Key
tasks include:

NOTE:

For firmware versions earlier than 2.0.0.0, no configuration tasks are available.

•

Enable or disable Multi-initiator mode.

•

Create the zone groups.

For deployments with shared SAS storage enclosures and tape libraries, create
switch-port zone groups.

◦

◦

For deployments with zoned SAS storage enclosures, create drive-bay zone groups.

•

Assign zone groups to servers.

3.

Capture the configuration for safekeeping. HP strongly recommends this step, especially in
single-domain configurations. (Available only in the VSM CLI.)

Configuration information is located as follows in this guide:

•

Example procedures:

“Example: Configuring shared SAS storage enclosures” (page 18)

•

Example procedures:

“Example: Configuring zoned SAS storage enclosures” (page 27)

•

Field details

“Tasks in the VSM Zoning tab” (page 34)

•

Field details

“Tasks in the VSM Maintain tab” (page 44)

Configuring the switch (key steps)

17

Advertising