HP Color LaserJet 4600 Printer series - Manual (Page 51)

ENWW 37
5. Press ✔ to select SYSTEM SETUP .
6. Press  to highlight CLEARABLE WARNINGS .
7. Press ✔ to select CLEARABLE WARNINGS .
8. Press  or  to select the appropriate setting.
9. Press ✔ to set the selection.
10. Press P AUSE /R ESUME .
Auto continue
You can determine printer behavior when the system generates an
Auto Continuable error.
ON is the default setting.
z
ON displays an error message for ten seconds before
automatically continuing to print.
z
OFF pauses printing any time the printer displays an error
message and until you press ✔ .
To set the auto continue
1. Press ✔ to enter the MENUS .
2. Press  to highlight CONFIGURE DEVICE .
3. Press ✔ to select CONFIGURE DEVICE .
4. Press  to highlight SYSTEM SETUP .
5. Press ✔ to select SYSTEM SETUP .
6. Press  to highlight AUTO CONTINUE .
7. Press ✔ to select AUTO CONTINUE .
8. Press  or  to select the appropriate setting.
9. Press ✔ to set the selection.
10. Press P AUSE /R ESUME .
Supplies low
The printer allows two options for reporting that supplies are low;
CONTINUE is the default value.
z
CONTINUE allows the printer to continue printing while displaying a
warning until the supply is replaced.
z
STOP causes the printer to pause printing until you replace the
used supply or press ✔ , which allows the printer to print while
continuing to display the warning.