HP Color LaserJet 4600 Printer series - Manual (Page 62)

48 ENWW
To configure the Novell NetWare parameters from the
printer control panel
1. Press ✔ to enter the MENUS .
2. Press  to highlight CONFIGURE DEVICE .
3. Press ✔ to select CONFIGURE DEVICE .
4. Press  to highlight I/O .
5. Press ✔ to select I/O .
6. Press  to highlight EIO X (where X = 1, 2, or 3).
7. Press ✔ to select EIO X .
8. Press  to highlight NOVELL .
9. Press ✔ to select NOVELL .
10. Press  to highlight FRAME .
11. Press ✔ to select FRAME .
12. Press the P AUSE /R ESUME button to return to the ready state.
Note The default frame type value for the HP Color LaserJet 4600 is
automatic.
Configuring TCP/IP parameters
You can use the printer control panel to configure the following
TCP/IP parameters:
z
usage of the BOOTP file for configuration parameters (the default
is to use the BOOTP file)
z
IP address (4 bytes)
z
subnet mask (4 bytes)
z default gateway (4 bytes)
z
TCP/IP connection timeout (in seconds)
Note Do not disable BOOTP if you will be using RARP or DHCP to
configureTCP/IP parameters.
To automatically configure TCP/IP parameters from
the printer control panel
1. Press ✔ to enter the MENUS .
2. Press  to highlight CONFIGURE DEVICE .